Capabilities
Five disciplines,
one delivery team.
01 · Introduction
Engineering, fabrication and commissioning under one roof. The same people who specify a system are responsible for handing it over running.
Service · 01
Design & Construct
Single-source delivery. The team that designs the system is the team that fabricates, installs, and commissions it — one accountable party from brief to handover.
What’s included
- End-to-end mechanical services D&C
- Detailed design, drawing, and specification
- Procurement and trade coordination
- Site install, integration, and tie-in
- Commissioning, load-prove, and handover
Service · 02
Pre-Fabrication
Skid-mounted plant assemblies built and pre-commissioned offsite — installed in days, not weeks. Best where site access, shutdown windows, or weather are constraints.
What’s included
- Modular chiller, AHU, and pump skid design
- Offsite fabrication in controlled workshop conditions
- Pre-commissioning and factory acceptance test (FAT)
- Transport, crane lift, and site placement
- Site tie-in and final commissioning
Recent Pre-Fabrication projects
Service · 03
Maintenance
Planned and reactive service contracts for critical mechanical plant. 24/7 response, condition-based scheduling, and full digital records of every visit.
What’s included
- Planned preventative maintenance (PPM) contracts
- 24/7 reactive call-out and breakdown response
- Condition monitoring and trend reporting
- Refrigerant logbook, leak detection, and reporting
- Asset lifecycle planning and replacement budgeting
Recent Maintenance projects
Service · 04
GTIC
Gas turbine inlet cooling. Lower the inlet air temperature, lift the power output. We design, supply, install, and commission GTIC systems for power generation operators across Australia.
What’s included
- Evaporative and chiller-based GTIC system design
- Output uplift modelling and ROI analysis
- Retrofit and new-install delivery
- Water treatment and balance-of-plant integration
- Seasonal commissioning through summer peak
Recent GTIC projects
Service · 05
Consulting
Mechanical services design, peer review, and expert input for clients who need an experienced second set of eyes — or a primary one.
What’s included
- Concept and detailed mechanical services design
- Peer review of third-party design packages
- Feasibility studies and options analysis
- Expert witness and dispute support
- Commissioning agent and independent witnessing
Recent Consulting projects
Get in touch
Have a brief that touches more than one of these?
Most QEG projects span at least two services. Send us the scope and we’ll respond with a shaped proposal.
Start a conversation →